FLAT WEBBING SLING ROUND WIRE MALE AND FEMALE RINGS – B 5 TYPE

These category 5 flat webbing slings are conceived for tie-lifting with their male and female round wire rings at each end. We manufacture them up to 20 T according to EN 1492-1+A1 standard.

The range benefits

The male ring slides perfectly into the female one and makes it possible to lift the load without boring or folding the sling.
Galvanized rings for increased lifespan.
Traceability is guaranteed by the traceability label.
Polyester provides high resistance to friction, abrasion, UV and chemical products.

Our advantages

Customization available
French manufacturer guarantee

About this product

B-type flat webbing sling (double ply) with two male and female round wire rings (category 5).
Be careful, according to standard EN 1492-1+A1, make sure to always protect your slings if used in a lifting configuration with sharp angles.
A wide range of protections is available: polyurethane, PVC or leather sleeve, polyurethane protection keeper, etc.
Contact us to know the other optional materials available for ends reinforcement. For lifting capacities higher than 20 tons, use C-type slings (4 plies).
  • Features

  • Download center

Features

ReferenceSPB5
Min WLL0,5 T
Max WLL20 T
Safety factor4:1 for the whole set (the webbing keeps a safety factor of 7:1)
StandardEN 1492-1+A1
Material100% high tenacity multifilament polyester
Min webbing width30 mm
Max webbing width300 mm
ConfigurationB-type: 2 plies
Category1 male and 1 female round wire ring (cat. 5)
Min effective working length1 m
Max effective working length100 m
Weight 1st mFrom 850 up to 23500 g
Weight linear meterFrom 200 up to 2250 g
Operating temperatureFrom - 40°C up to + 100°C
ColourAccording to WLL: 1 T purple, 2 T green, 3 T yellow, 10 T and more orange

Download center

Schéma / Visuels

Important information

Your safety depends on the proper use of your product. Refer to the user manual supplied with the equipment.
Depending on your needs and / or your site, we can pair your slings to guarantee them the same length.
Data such as weight are given for information purpose only and may be changing depending on the manufacturing method and the raw material sourcing.
We can test our production up to the highest capacities in our laboratory with fatigue or static under proof load tests.

Choosing PMS also means:

Choosing a French manufacturer

Quick delivery

Personnalized support

Any question?